Best way to fix rusted roof guttering?
Question by nunnaya: Best way to fix rusted roof guttering?
I have a rust hole in my roof guttering that is usually dripping water. it is only a tiny patch, and the only rusted part of the complete roof gutter, so I do not program on replacing it.
What’s the ideal way to fix this to make it look like new (from beneath at least)? The rusted location is not much a lot more than an inch in diameter.
Thanks extremely considerably!
Very best answer:
Answer by robnrobn2000
Just cut that section out and replace it. Take it to a guttering organization and they will possibly give it to you!
Give your answer to this question below!
You can try using epoxy. Use a fiberglass or wire brush to remove as much as you can. Use epoxy to cover the hole. Some epoxies can be tinted as well, which will save you the trouble of having to paint the repair once the epoxy dries.
Depending on the actual size of the hole, you might be able to cut a couple of inches on either side of the whole and replace just that little section vs. the entire 10 foot piece. You also might be able to slice through the gutter at that point and use a seam to cover the damage, but cutting along a straight line and through a hole is difficult at best.
What you want to do is get a piece of gutter that matches the shape of your gutter. You then want to cut off the front lip. you can then dry fit the piece of gutter in the original gutter that is on the house by placing it in the gutter and seeing if it fits. You then want to lay a bead of sealant/adhesive around the place where the “patch” will sit. You can then place the patch in the gutter and press it down and make it sit good.
Since the edges are most likely rusty, too, trim off about half an inch around the hole. If you have a tin can in the kitchen, don’t throw it out just yet. Recycle. Use the top lid. This would be just about the right size to cover a two-inch hole. Flatten it with a mallet. Be careful not to flatten your fingers along with it. Buy elastomeric sealant from your hardware store. If they have the economy size pack, go get that one because you will only need a little amount. Apply the elastomeric sealant around the tin can you have prepared.Make certain the edges around the hole is dry and clean. Center the tin can on the hole, applying just a bit of pressure to ensure proper adhesion. You’ve plugged that hole.Paint the underside. I hope your gutter’s got an off-the-shelf color so it won’t be difficult to match colors. By the way, since you’ll be working on an elevated area, practice safe fall prevention techniques.